Portable Single Core 0.9mm Fiber Optic Cleaver

Portable FTTH Optic Cable Cutting Tool High Precision Single Core Fiber Optic Cleaver

Features :

* Compact design;
 

* High reliability;
 

* Superior cleaving performance;
 

* Special hexagonal wrench placement design;
 

* 48,000 times cleave per blade;
 

* Very light.
 

* Black color

Instructions fiber cleaver:

1. Use Please read these instructions carefully before;

2 .cleaver knife is precision machinery, can not withstand strong impact, so as not to affect the cutter performance

3.Optical fiber and optical fiber debris is very slim, and the tip of a sharp, use strictly prevent fiber debris from entering the skin, eyes, optical fiber debris with special container collection

4. Do not directly touch the blade, maintenance, do not touch the blade;

5. Do not split the cutter or to its oil needs repair, please contact the manufacturers service department

perating Method:

1, large platen opening and closing lever lift open large platen fixture cover the blade slider pushed to the front side of device, waste fiber recycling the superstructure will automatically open;

2, with the stripped fiber clamp stripped fiber coating reserved for bare fiber length 35-45 mm, moistened with alcohol cotton wool or tissue paper wrap optical fiber, fiber clean. Wiping with cotton wool or tissue, do not use the same cotton wool or tissue paper to rub the second (Note: Please purity greater than 99% alcohol);

3, visual to the edge of the fiber coating layer is aligned with the cutter on the ruler (10-16 cm) appropriate scale, left the optical fiber into the fiber guide grooves require a bare fiber placed straight on the optical fiber pressure pad to determine the end of the fiber can be touched recycle the rollers;

4 Close the fixture cover platen, to promote the device blade slider, the blade dicing the lower surface of the optical fiber, and is free to slide to the other side, cut off the fiber;

5, left hand held onto the cutter right hand to open the large platen waste fiber will automatically be placed in the waste fiber collection box,;

6, With the left hand and hold the optical fiber while his right hand to open the fixture cover, carefully remove the fiber cut end face: the neat fiber cross-section not to touch and it is matter

7, Troubleshooting, cutting bad reasons may be:

1), fiber is not straight on the fiber-optic pressure pad;
2), the blade height is too high;
3), blade, sanding pad dust and other foreign matter

Specifications:

Application:

1,Fiber Optical Communication Systems

2,Optical Fiber CATV

3,Passive Optical Network (PON)

4,Fiber Optic Amplifiers

5,Fiber Optic Access Networks/LAN

6,Monitoring Systems

7,Optical Fiber Sensor

Picture :